I produced as much as I could in Belgium to keep control over the quality and the finish of the products. This was not always easy given the customs tariffs in the United States and Russia. In Asia, I had samples made to my specifications, based on my own samples, which enabled me to check the quality. I created a 2D design, followed by a 3D model, to convey the intended ambience to the client. Once the client gave the go-ahead, I drew the production drawings, which I then sent to the client. A local contractor processed them and sent them back to me to be checked. This process was then repeated time and again, until the drawings were fully compliant with the design that I had created.